The UK Dart 15 Association

Replacing inspection hatch

Dart 15 Chat
Post Reply
Kevin Parvin
Lieutenant
Lieutenant
Posts: 134
Joined: Sun Dec 17, 2006 4:50 pm

Replacing inspection hatch

Post by Kevin Parvin »

After leaking for some time I’ve finally got round to replacing the rear hatch mounts on 1615. Carefully removing the mount, and cleaning up the old sealant has revealed a rather damaged set of rivet holes. Is the best thing to fill in and repair the old holes, then start again and drill six new river holes.
As the rivet attachments lie near the edge of the opening, is the process of ‘riveting’ splitting the gelcoat? Would I be better using short stainless steel bolts (flush fitting).
Any thoughts appreciated.

Thanks
Kevin
1615
Attachments
C9E8CC3B-D268-42A9-9F09-E89D8484A32B.jpeg
C9E8CC3B-D268-42A9-9F09-E89D8484A32B.jpeg (127.35 KiB) Viewed 3373 times
Post Reply
cron